NOTE: best practice dictates that the machine be lifted no more than just enough
to clear the ground. Running the machine at an extreme angle could damage the
PTO
.
3.19 - Working Limitations
When using the tilling rotor, if the blades will not penetrate the ground easily or the
machine jumps and vibrates excessively, conditions may be too dry, tough or
compacted. (Also make sure that the blades are properly installed
11
with the proper
scroll and the bolts properly torqued
12
).
Under these extreme conditions it may be wise not to use the tiller as a primary tillage
tool. Run over the ground with a disc or plow prior to tilling.
3.20 - Uneven Terrain
DANGER: be careful when operating tractor and machine over uneven ground to
avoid rollover. In extremely uneven terrain rear wheel weights, front tractor
weights and/or tire ballast should be used to improve stability.
When working over uneven terrain, observe the type of terrain and develop a safe travel
pattern. Whenever traction or stability is doubtful, first test drive over the terrain with the
PTO
disengaged.
Operate the machine up and down steep slopes, not across slopes, to prevent the
tractor from tipping. Avoid sudden stops and starts and slow down before changing
directions on a slope.
Pass diagonally through sharp dips and avoid sharp drops to prevent hanging up the
tractor and machine.
Slow down on sharp turns and slopes to prevent tipping or loss of control.
Avoid tipping the machine while working. Watch for holes, roots or other hidden objects.
Do not work near the edge of a gully, ditch or stream bank.
3.21 - Transporting
CAUTION: All operations of transport are to be done without the Green-Rite
working and respecting all local traffic rules and regulations.
O
PERATION
27
R
OTOMEC
G
REEN
-R
ITE
O
PERATOR
’
S
M
ANUAL
12
See table 4, page 32.
11
See paragraph 4.04 - Blade Maintenance.
