Programming the remote control
Programming the remote control (variant 1)
This description applies to the following products:
•
Roller shutter ZRO EF
•
Awning ZMA EF
•
Radio receiver FE 24 V
•
Radio receiver FE 230 V
•
Remote-controlled socket FSD
1) Programming the master transmitter (hand-held
transmitter)
a) Preparing the receiver for programming
A hand-held transmitter is needed as a master transmitter.
Operate the programming button on the transmitter using a
suitable cylindrical tool (e.g. a ballpoint pen).
•
Switch off the power supply to the receiver for 5 seconds, then switch it
back on
or
•
Operate the programming button or the radio switch of the receiver.
The receiver is now in programming mode for 3 minutes.
b) Programming the master transmitter (hand-held transmitter)
Press the programming button on the master transmitter whilst in program-
ming mode until the receiver confirms that programming has been successful.
The programming process is now complete.
2) Programming additional transmitters (radio light
sensor)
1.
Press the programming button of the master transmitter until the re-
ceiver confirms.
2.
Then press the programming button of the new transmitter until the re-
ceiver confirms.
3.
Now press the programming button of the new transmitter again.
4.
The receiver confirms successful programming.
25 - en
