20
PRESSURE SIDE
OF CIRCULATION PUMP
LOOKING FROM BOTTOM
FRONT GEARBOX
RESERVOIR
LUBRICATION
DISENGAGE & SHUT OFF POWER BEFORE LUBRICATING THE MACHINE.
LOOSE OR FLOPPY CLOTHING SHOULD NOT BE WORN BY THE OPERATOR.
PTO SHAFTS & U-JOINTS:
Grease every 10 to 20 hours.
IT IS RECOMMENDED THAT ALL TRUCK HYDRAULIC RESERVOIRS (except the
gearbox reservoir) USE (CITGO TRANSGARD TRACTOR 10W HYDRAULIC FLUID
OR EQUIVALENT) .
All reservoirs (except the gearbox reservoir) should be changed every 2000 hours or every
year, which ever comes first. Approximate volume of oil is 32 gallon per reservoir. All filters
should be changed the first 100 hours then every 1000 hours or with every fluid change. 10
micron filter elements are recommended. The reservoir should be checked daily for proper
fluid level. Visually check daily for any fluid leakage.
GEARBOXES:
After the first 100 hours of operation, drain initial oil, preferably when box is
warm. Flush out the gear case with an approved non-flammable, non toxic solvent and refill
with oil. Thereafter oil should be changed every 2000 hours or 12 months, whichever
comes first. If machine usage is severe or more than 10 loads per day, it is advisable to
change the oil every 1000 hours or 6 months. Inspect and wash oil reservoir breather cap
as needed. Air dry before reinstalling. Fill each gearbox with approximately 13 gallon of
MOBIL DELVAC SYNTHETIC GEAR OIL 75W-90
.
PROCEDURE FOR FILLING GEARBOXES:
Remove pressure side oil line from
circulation pump and attach to oil supply pump. Pressure oil in gear box until oil starts to
show in bottom of sight gauge on oil reservoir. Reconnect oil line to circulation pump. Fill
reservoir to center of sight gauge, run unit and add oil up to center of sight gauge if
needed.. Check daily, oil level must always be visible in sight gauge.
Note: Do not fill
gearbox through oil reservoir after draining the gearbox and refilling, use procedure
described above.
After the gearboxes are full extra oil can be added through the reservoir.
RECOMMENDATION:
It is advisable to check the oil level of gearboxes at least once a
month. If more than 10% of the total oil capacity has to be added, check for oil leaks.
GEARBOX TEMPERATURES:
During normal running conditions, the temperature of the
outer casing of the gearbox should not exceed 175ºF (80ºC).
Summary of Contents for 1105H
Page 2: ...2 ...
