1
Horizontal Electrophoresis System
4849.1 ROTIPHORESE
®
PROfessional runVIEW System
4850.1 ROTIPHORESE
®
PROfessional runVIEW Base for
electrophoresis unit ROTIPHORESE
®
PROfessional III (2850)
9958.1 ROTIPHORESE
®
PROfessional runVIEW Base MINI 1 for
electrophoresis unit ROTIPHORESE
®
PROfessional I (2788)
9961.1 ROTIPHORESE
®
PROfessional runVIEW Base MINI 2 for
electrophoresis unit ROTIPHORESE
®
PROfessional II (2799)
runVIEW
– made by Cleaver Scientific Ltd, UK
Warning:
The runVIEW real-time horizontal DNA electrophoresis system has been thoroughly tested
and found to comply within the limits of CE regulation. It has been manufactured using the latest
technology and does not require maintenance. When used correctly this unit poses no particular
health risk, although it can deliver dangerous voltage levels if used incorrectly. Accordingly,
this
power supply must only be operated by fully qualified personnel adhering to the guidelines laid
out within this instruction manual.
Although this power supply is equipped with all necessary safety
features against abuse and accidental failure, caution should always be exercised when working with
high voltage equipment. Any individual intending to use this instrument should read the entire manual
thoroughly before operation.
The horizontal electrophoresis units from ROTH are designed for long term laboratory use and to
obtain reproducible results. Please spend a few moments reading the instruction manual thoroughly.
These units comply with the statutory CE safety rules:
73/23/EEC: Low voltage directive: IEC 1010-1:1990 plus amendment 1:1992
EN 61010-1:1993/BS EN 61010-1:1993
Please verify that you received the unit completely and without any damage. Any faults or losses have
to be reported to ROTH immediately. ROTH can not accept responsibility for goods that were sent
back without informing them.
Please take a look at the packing list and check whether all components and accessories are present.
Please retain all packaging material until the warranty period has expired.
Environmental Conditions
This unit may only be installed and operated only under the following environmental conditions:
o
This apparatus is intended for indoor use only.
o
The unit can be operated safely at an altitude of 2000 m.
o
The normal operating temperature range is ambient to 40 °C.
o
Atmospheric pressure: 75 kPa
– 106 kPa
o
Relative humidity:
≤
95 %
This apparatus is rated POLLUTION DEGREE 2 in accordance with IEC 664.
POLLUTION DEGREE 2, states that: “Normally only non-conductive pollution occurs. Occasionally,
however, a temporary conductivity caused by condensation must be expected”.
All ROTH products are supplied having passed rigorous quality control procedures. For
additional questions please give us a call: ++49-721-5606-0
