15
Remote Control Advanced Buttons
MENU Button
H
Remote Only
By pressing the MENU button, you can enter the following setup menu:
• DISPLAY DIMMER: Changes the display brightness.
• POWER LED DIMMER: Changes the Power LED brightness.
NOTE:
These settings are stored permanently even after the RCD-1572 is
powered off.
• VERSION: Shows the current software version.
• AUTO POWER OFF: The unit can be configured to automatically power
off if unused for a specified period. If the CD is stopped for the specified
“Auto Power Off” time the unit will automatically go to STANDBY mode.
The Auto Power Off timer will be restarted if the CD starts to play. The
default for Auto Power Off is set to DISABLE.
Valid settings include: DISABLE, 30 mins, 60 mins, 90 mins.
• EXIT: Exits this SETUP menu.
From the remote control, press the up/down arrow buttons to change the
contents of the menu, and press ENT to enter the settings or confirm.
NOTE:
You can also access the SETUP menu without the remote control.
Press the STOP button on the front panel for 5 seconds. Press the TRACK
buttons to change the contents of the menu and press STOP button to
enter the settings or confirm.
DIM Button
C
Remote Only
Press the DIM button sequentially to change the DISPLAY brightness.
NOTE:
Adjustments made using the
C
button are temporary only and
not saved after powering off the RCD-1572.
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections, or
improper control settings. If you encounter problems, isolate the area of the
difficulty, check the control settings, determine the cause of the fault and
make the necessary changes. If you are unable to get sound from the unit,
refer to the suggestions for the following conditions:
Power Indicator Is Not Illuminated
The Power Indicator and the basic items in the display window should be
illuminated whenever the unit is plugged into the wall power outlet and the
Power button is pushed in. If it does not light, test the power outlet with
another electrical device, such as a lamp. Be sure the power outlet being
used is not controlled by a switch that has been turned off.
Fuse Replacement
If another electrical device works when plugged into the power outlet,
but the Power Indicator and the display still will not light when the unit is
plugged into the wall outlet, it indicates that the internal power fuse may
have blown. If you believe this has happened, contact your authorized Rotel
dealer to get the fuse replaced.
No Sound
Check the cables between the unit and the amplifier inputs to be sure they
are connected properly. Be sure the correct amplifier input is selected. Be
sure the tape monitor system of the amplifier has not been activated. Check
the wiring between the amplifier and the speakers.