10
RCD-12 Stereo Compact Disc Player
the button a second time displays the time remaining on the entire disc
(or memorized program). Pressing the button a third time reverts to the
standard elapsed time display. When the TIME feature is activated, the
icon appears in the Display in front of the time.
Note:
When playing MP3 and WMA discs, only the regular elapsed
time and the time remaining in the current track can be displayed.
Rotel-Link
q
This 3.5 mm stereo mini-jack (labeled ROTEL LINK IN) receives command
codes from another Rotel-Link OUT enabled unit in the Rotel series of
products. Allowing a set of products to operate as one using the ROTEL
remote application. See Figure 3 for connections..
12V Trigger Connection
w
The RCD-12 can be activated by a 12 volt trigger signal from a Rotel
preamplifier.The trigger input accepts any control signal (AC or DC)
ranging from 3 volts to 30 volts. When a cable is connected to the input
and a trigger signal is present, the CD Player is activated.
When the trigger signal is interrupted, the unit goes into standby mode.
The front panel indicator light remains lit , but the display goes dark and
the unit will not operate.
NOTE:
When using the 12V Trigger feature, leave the POWER button
in the ON position.
Remote Control Advanced Buttons
SETUP Button
O
Remote Only
By pressing the SETUP button, you can enter the following setup menu
1. DIMMER- changes the display brightness in 7 steps.
2. FACTORY DEFAULT - Resets to factory default. Select <YES> and
press PLAY to confirm.
3. VERSION - Displays the current software version.
4. DISPLAY CONTRAST - Sets the contrast of the display.
5. EXIT - Exits this SETUP menu.
From the remote control, press the STOP/PAUSE/TRACK+/- keys to change
the contents of the menu, press PLAY to enter the setting or confirm.
Note:
You can also access the SETUP menu without the remote control.
Press the STOP key on the front panel for 5 seconds. Press the TRACK
buttons to change the contents of the menu and press STOP to enter the
settings or confirm.
DIM Button
P
Remote Only
Press the DIM key sequentially to change the DISPLAY brightness. This
the same as the DIMMER function under the SETUP menu.
UPGRADE USB mini socket
r
This socket is reserved for future software upgrades when necessary.
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections,
or improper control settings. If you encounter problems, isolate the area
of the difficulty, check the control settings, determine the cause of the fault
and make the necessary changes. If you are unable to get sound from the
RCD-12, refer to the suggestions for the following conditions:
Power Indicator Is Not Lit
The Power Indicator and the basic items in the Display window should
be lit whenever the RCD-12 is plugged into the wall power outlet and
the Power button is pushed in. If it does not light, test the power outlet
with another electrical device, such as a lamp. Be sure the power outlet
being used is not controlled by a switch that has been turned off.
Fuse Replacement
If another electrical device works when plugged into the power outlet,
but the Power Indicator and the Display still will not light when the RCD-
12 is plugged into the wall outlet, it indicates that the internal power
fuse may have blown. If you believe this has happened, contact your
authorized Rotel dealer to get the fuse replaced.
NO SOUND
Check the cables between the RCD-12 and the amplifier inputs to be
sure they are connected properly. Be sure the correct amplifier input is
selected. Be sure the tape monitor system of the amplifier has not been
activated. Check the wiring between the amplifer and the speakers.
