9
English
Troubleshooting
Most difficulties in audio systems are the result of poor or wrong
connections, or improper control settings. If you encounter problems,
isolate the area of the difficulty, check the control settings, determine
the cause of the fault and make the necessary changes. If you are
unable to get sound from the RB-1592, refer to the suggestions for the
following conditions:
Power Indicator Is Not Lit
No main power to the RB-1592. Check AC power connections at the
amplifier and the AC outlet. Check the front panel power switch. Make
sure that it is set to the ON position.
No Sound
If the amp is getting AC power, but is producing no sound, check
the PROTECTION INDICATOR on the front panel. If lit, see below. If
not, check all of your connections and control settings on associated
components.
Protection Indicator Is Lit
The front panel PROTECTION INDICATOR lights when the RB-1592
protection circuits have shut off the amplifier. Typically, this occurs
only when the ventilation openings are blocked, when there is faulty
speaker wiring, or after a period of extreme use. Turn off the system
and wait for the amp to cool. Then push the front panel power
switch in and out to reset the protection devices. If the problem is
not corrected or reoccurs, there is a problem with the system or the
amplifier itself.
Specifications
Continuous Power Output
(20-20k Hz, <0.03%)
380 watts/ch into 8 ohms
700 watts/ch into 4 ohms
Total Harmonic Distortion
(20Hz - 20kHz, 8 ohms)
< 0.03%
Intermodulation Distortion
(60Hz:7kHz, 4:1)
< 0.03%
Damping Factor
(20Hz-20kHz, 8ohms)
1000
Input Impedance/Sensitivity
12 kohms/2.6 volts
Amplifier Gain
26.5dB
Frequency Response
(±1db)
10Hz - 100Khz
S/N Ratio
(IHF A)
125 dB
Crosstalk / Separation
> 70 dB
Speaker Impedance
4 ohms minimum
Power Requirements
USA: 120 volts, 60Hz
Europe: 230 volts, 50Hz
Power Consumption
800 watts
Idle: 70 watts
Standby
<0.5 watt
Dimensions
(W x H x D)
431 x 237 x 410 mm
17 x 9
3/8
x 16
1/8
in
Weight
(net)
40 kgs, 88.18 lbs
Panel Height
5U/221mm/8
3/4
in
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co.,
Ltd.,Tokyo, Japan.
