10
WARNING
Before attempting to lift any vehicle, be
sure that:
A. Vehicle individual axle weight does not exceed two lift
columns combined capacity.
B. Lift forks are in secure contact with vehicle tires.
C. Adequate overhead clearance is provided to raise
vehicle to desired height.
D. Parking brake is released on vehicle.
E. Adjustable forks must be equally spaced off centerline
of lift carriage, and adjusted to properly accommodate
the tire/wheel size.
F. Ensure tires are properly inflated before lifting. DO NOT
exceed tire load rating when raising vehicle.
9. To Raise Lift:
A. Ensuring that the System Configuration Lock/Unlock
light is green, press the Raise Button. Raise the vehicle
until vehicle tires clear the floor.
Check Fork Contact: Stop and check for secure fork contact
with tires, at all columns.
B. Continue to raise the vehicle to desired height.
NOTE: While cycling the lift, you may observe the individual
columns slowing down and speeding up at various stages
of travel. This is a normal characteristic of the lift leveling
system.
Monitor the safety locks while raising the lift by listening for
the mechanical lock clicking.
Do Not go under vehicle unless all tires are in secure
contact with forks. Lower lift and repeat vehicle and/or lift
spotting and loading procedure if required.
C. Press the Lower To Locks Button to lower columns onto
the locking latches.
10. While Using Lift: Avoid excessive rocking of vehicle
while on the lift.
11. Before Lowering Lift: Remove tool trays, safety stands,
etc. from area.
10.To Lower Lift:
A. Ensuring that the System Configuration Lock/Unlock
light is green, press the Raise Button to raise lifts off the
locks.
B. Press the Lower Button to lower lift. The Slow Lower
Button (1/3 speed) can be used if desired. Observe that
all columns are lowering and vehicle remains level.
C. Remain clear of forks and vehicle when lowering.
Observe pinch point WARNING decals.
D. Reset the parking brake.
E. Move all lift units away from the vehicle to provide an
unobstructed exit before removing the vehicle.
Summary of Contents for HydroLift MC62
Page 9: ...9 Fig 3 Fig 4 Fig 2 Power Up Switch...
Page 18: ...18 HYDRAULIC SCHEMATIC...
Page 19: ...19 NOTES...
