10
3.5 Connect power
Connect the red wire to the positive pole of the battery and connect the black wire to the negative
pole of the battery. Connect the yellow wire to the ignition signal (+DC) of the vehicle. The fuse
should be connected to the positive pole and red wire. Please note: the fuse is used for protecting
the DVR, so the fuse should be placed AS near to the battery positive pole as possible.
NOTE
1.
The DVR uses a DC power input only;
please be very careful when connecting to the “+” and “
-
”
of the power supply.
2.
Wide voltage range of 8V-32V for the DVR. The DVR may be damaged if the voltage is outside of
this range.
3.
Power consumption of the DVR can be 60W when the engine starts. All the cables for connecting
from power to the DVR should be thick enough for current over 5 Amperes.
3.6 GPS connection (Optional 250-8902)
Connect the GPS receiver to the GPS connector on the cable harness.
