Rostra Precision Controls, Inc. - 2519 Dana Dr. - Laurinburg, NC 28352 - 800-782-3379 - rostra.com
Page 3
Testing and Reassembly
Testing
1.
Reconnect the negative battery cable and torque to 3 ft-lbs.
2.
Re-enter any theft deterrent information (if applicable).
3.
Turn the ignition switch to ON. Place the vehicle in reverse gear. Verify that the camera’s picture appears.
Note:
If there is no picture present, re-check all harness connections.
Reassembly
1.
Reinstall all trim pieces taking special care to ensure harnesses and wiring connections are properly secured.
2.
Make sure no harnesses are bent or pinched by trim pieces.
3.
Reconnect all disconnected bulbs and check for function.
Installation Tips
•
Confirm proper cable extension connector orientation and always verify proper ends are routed in correct
direction.
•
It is a good idea to dry-fit all pieces in this kit before permanently attaching them to ensure proper
orientation and operation before beginning installation for familiarization with components.
•
Always treat any metal exposed during installation with a rust preventative compound to prevent system
failure due to rust and/or corrosion.
•
Always seal any holes drilled with the provided sealing putty to prevent water infiltration through
unprotected areas.
•
Confirm integrity of mechanical and electrical connections before moving to next installation sequence.
Installation Notes
_____________________________________________________________________________
