Rostra Precision Controls, Inc. - 2519 Dana Dr. - Laurinburg, NC 28352 - 800-782-3379 - rostra.com
Page
3
•
Solid black wire from camera harness 250-8583 to chassis ground.
•
Red wire from camera harness 250-8583 to accessory 12-volt power.
•
DC male power connector from camera harness 250-8583 to DC female power connector of LCD monitor.
•
Backward In wire from LCD monitor to vehicle 12-volt reverse signal.
•
Blue trigger wire from camera harness 250-8583 to vehicle 12-volt reverse signal (opens shutter).
Note:
Video 1 In (yellow) of LCD monitor is not used in this application, but is available for use with any
device that provides video via a standard RCA connection.
Monitor Mounting (with attached stem)
•
Remove existing rearview mirror from vehicle.
•
Mount RearSight monitor to attached windshield lug and tighten screw.
•
Route camera extension harness to the rear of the vehicle.
•
Secure harnesses with wire ties.
Monitor Mounting (with included dash mount)
•
Before removing adhesive backing, form pedestal base tabs to fit the contour of the dashboard where the
monitor is to be installed.
•
Once dry fitment is complete, attach the LCD monitor to the pedestal mount to verify placement and
security of fasteners that connect the monitor to the mount.
•
Thoroughly clean desired mounting space on dashboard to ensure proper adhesion of the mounting tape.
Note:
By failing to properly form base tabs, the pedestal mount will not secure to the dashboard.
Camera Mounting
When choosing a mounting location for your camera, choose a location that meets the following requirements:
•
The camera is mounted in a manner that provides a clear view of the area behind the vehicle that needs to be
visualized in the monitor. When possible, this should include a portion of the rear of the vehicle so as to
provide a point of reference for the driver.
