Controller Operation
AYC-F/G/M60 Series Installation and Programming Manual
61
5.
Enter the assignment digit for the current user slot:
1
activates the Lock Strike relay only default
2
activates the Auxiliary relay only
3
activates the Lock Strike and Auxiliary relays
If the assignment digit is valid, three beeps are heard and the
controller returns to Normal mode.
If the assignment digit is invalid, a long beep sounds and the
controller waits for another assignment digit to be entered.
5.9.16
PIN Code Length/Factory Default Settings
You must be very careful before using this command! Changing
the PIN code length also erases the entire memory contents,
including all user and special codes, and returns all codes to
their factory default settings.
To change the PIN code length:
1.
Enter Programming mode.
2.
Select the desired PIN code length as follows:
00
– Returns to factory defaults and sets a 4-digit code
05
– Returns to factory defaults and sets a 5-digit code
06
– Returns to factory defaults and sets a 6-digit code
08
– Returns to factory defaults and sets a 4-8 digit code
When choosing the 4-8 option, please note that you should
either enter zeros before the code, or press pound at the end
(for example if your code is 12345, enter either
00012345
or
12345#
).
Both LEDs flash red.
3.
Enter your 4-digit Programming code.
Red
Red
Green
