Installation
10
AY-Q6x60 Series Installation and Programming Manual
2.
Installation
Installation of an RFID reader adjacent to metallic surfaces
might alter the reader’s specifications. To diminish this
interference, use a plastic spacer when mounting the reader.
2.1
Mounting
Before starting, select the location to mount the unit. This location
should be at shoulder height.
To mount the unit:
1.
Peel off the back of the self-adhesive installation template and
attach the template to the required location.
2.
At the bottom of the unit’s case, remove the screw.
3.
Remove the cover by gently sliding it up and then pulling it
apart. Once you remove the cover, you will see the screw holes
for mounting.
4.
Depending on the type of installation, gang box or panel mount,
drill the respective holes in the rear cover: for gang box
mounting, drill two holes marked “A”; for flat panel mount, drill
four holes marked “B” (Figure 1).
Figure 1: Drilling Mounting Holes