CLEANING INSTRUCTIONS:
1.
To maintain the quality of your EZ-PRO™ container, w
ash all parts
daily in
warm soapy water
.
Use a non-abrasive sponge.
2. When disassembling the container, handle all parts gently. Please refrain from using too much force.
3. Reassemble the unit only after all parts are completely dry.
HOW TO DISASSEMBLE:
1.
Remove the container from the stand by holding it securely and lifting directly upward, clearing the hooks from the
notches on the stand.
2
. Remove lid from top of container. Make sure there is no remaining product inside that can spill over.
3
. Remove handle clip at the back of the container.
4
. Gently pull the handle from the front of the container.
Set aside both handle and label holder.
5
. Reach into container and remove p
ortion
wheel by gently pulling upwards or turning container upside down.
Do the
same to remove the nozzle.
HOW TO ASSEMBLE:
1. Place
nozzle
into container,
followed by the portion wheel.
3
.
Position the label holder so that it matches the hole on the front of the container.
5
. Place handle clip on the back end of the shaft. Make sure the words “This Side Out” are facing out.
6
. Fill container with desired dry product and place lid securely on the container.
7
. Follow steps
6
and 7
on Page 1.
Need a different-sized portion wheel? We have 6 more options for you to choose from!
Other portion wheels available:
•
Pro6-SM – 1 tablespoon
•
EZP0
07
– 1 teaspoon
•
EZP0
08
– 2 teaspoons
•
EZP01
0
– 3 teaspoons
•
EZP01
1
– 4
.5
teaspoons
The Rosseto interchangeable portion wheels deliver just the right amount of product
every time. Test each wheel with your dry foods to determine which works best for you!
Please contact our customer support at (847)763-1215 and we’ll be
happy to assist with any assembly questions, comments or concerns.
ROSSETO
®
3600 W. Pratt Avenue. Lincolnwood, IL 60712
Visit our website at:
www.rosseto.com
NEED ASSISTANCE?
CARING FOR YOUR CONTAINER
2
.
Adjust the portion wheel inside the container, so that
its
holes align with the container’s holes
(both front and back)
.
4
.
Insert handle through the label holder and front hole. Push the shaft through the portion wheel, all the way to
the back of the container.
