Ross Ultricool, User Manual

Page: 27 / 36

Ultricool User Guide (v1.0) Monitoring the Ultricool • 27
Monitoring the Ultricool
You can monitor the Ultricool from the front panel LEDs, the rear panel LEDs, and via the read-only fields in
DashBoard. Each location reports the status on a specific feature of the Ultricool.
Monitoring via the Front Panel LEDs
The Ultricool front panel includes LEDs that report the fan speed, power supply status, Ethernet communications,
and a general ALARM LED to indicate if the unit is operating normally.

Ensure the Setup > Front Panel Enable box is selected to enable monitoring from the front panel.
Refer to Table 8.1 for LED details.
For More Information on...
• the location of the LEDs on the front panel, refer to the section “ Front Panel Overview ” on page 13.
Table 8.1 Front Panel — LEDs
LED Color Description
AUTO Blue Ultricool is under Ultrix control
Purple Ultricool has started a RossTalk server
MIN Green Ultricool fans are set to manual speed mode. The
fans are set to the minimum RPM.
LOW Green Ultricool fans are set to manual speed mode. The
fans are set to 20% of the maximum RPM.
MED Green Ultricool fans are set to manual speed mode. The
fans are set to 50% of the maximum RPM.
HIGH Green Ultricool fans are set to manual speed mode. The
fans are set to 100% of the maximum RPM.
ALARM Red An error condition is detected on the Ultricool. It
is recommended to verify that the fans are
working or power supplies are functioning
correctly.
Off No alarm condition is detected
ENET Flashing Green There is currently communication activity on the
ENET port of the Ultricool rear panel
PWR 1 Green PSU 1 is present and working correctly
Off PSU 1 is not connected
PWR 2 Green PSU 2 is present and working correctly
Off PSU 2 is not connected