Ultricool User Guide (v1.0)
External Controls • 25
External Controls
This chapter lists the third-party protocol commands the Ultricool supports.
RossTalk Support
The RossTalk protocol is a plain text based protocol that allows control of Ross Video equipment.
Each command should be terminated by a carriage return and a line feed (CR/LF).
To establish communications using the RossTalk protocol
1. Display the
Setup
tab as outlined in the procedure “
To access the Ultricool interfaces in DashBoard
2. Use the
Device Control
menu to select
RossTalk client
.
To send RossTalk commands to Ultricool
1. On the RossTalk client, create a network connection to the Ultricool on
Port 7788
.
2. Set the
Fan Speed Mode
on the Ultricool to
Auto
. Refer to the section “
3. At the prompt, enter the commands you wish to send. Refer to
for a list of supported commands.
Table 7.1 RossTalk Protocol Commands
Message
Notes
Command
Description
fan_speed:###
Controls the fan speed where ### is the
speed percentage (0-100)
Summary of Contents for Ultricool
