Ross Synergy MD, Engineering Manual, Page: 210 / 388

8–6 • Output Configuration Synergy Q/MD Engineering Manual (v9.1 MD)
Connecting and Verifying Outputs
This section covers the following topics:
• Output Connection
• Output Verification
Output Connection
Connect the outputs to the desired external destinations, such as program monitors, preview monitors,
transmission, routing switchers, VTRs, etc.
Connect auxiliary outputs to external destinations, such as monitors, VTRs, routing switchers, etc.
Output Boards
• Fill in the desired destination for each output signal.
Output Verification
For verification of your outputs, ensure that some form of monitoring is available at the destination of
each specific output. The destination device itself may be a monitor, however, if the destination is a
VTR or a routing switcher, ensure that you can monitor the input signal to the specific device.
Note Before you begin, ensure that you have completed your Output
Worksheet .
Output Verification
To Verify This
Output
Do This ...
Program
Synergy 1 Q/MD : Press different crosspoint buttons on the BKGD bus.
Synergy 1.5 Q/MD : Press different crosspoint buttons on the PGM bus of MLE 2 .
Synergy 2 Q/MD : Press different crosspoint buttons on the PGM bus of MLE 2 .
Synergy 2.5 Q/MD : Press different crosspoint buttons on the PGM bus of MLE 3 .
MLE 1 PGM
Press different crosspoint buttons on the BKGD bus.
MLE 1 PV
Press different crosspoint buttons on the PST bus.
MLE 2 PGM
( Synergy 1.5 , 2 and 2.5 Q/MD only) Press different crosspoint buttons on the
BKGD bus of MLE 2 .
16 15 14 13 12 11 10 9 8 7 6 5 4 3 1 2
16 15 14 13 12 11 10 9 8 7 6 5 4 3 1 2
16 15 14 13 12 11 10 9 8 7 6 5 4 3 1 2
REF
LOOP
LOCK
CPU
100-120V~ 220-240V~ 47-63Hz
9A 650W (Canada 120V~onl
y
)
LAN1
10/100 10/100
LAN2
GP I/O P
ERIPH
1 P
ERIPH
2 P
ERIPH
3 P
ERIPH
4
P
ANEL
USB
LTC A
B
E
OUT
C
IN
D
IN
PS 2
PS 1
1
2
MAXIMUM
RATING
1950W
MD L
IVE
P
R
O
DUCTION
ENGINE
Output BNCs