Ross Synergy MD, Engineering Manual, Page: 172 / 388

7–2 • BNC Configuration and Check Synergy Q/MD Engineering Manual (v9.1 MD)
BNC Configuration
The following procedures will be discussed in this section:
• Naming Input BNC
• Setting Up Mnemonics Displays for BNC Names
• Setting Up BNC Types
• Setting Up Tallies
• Setting Up Alphas
• Setting Up Auto Keys
• Setting Up N/S Disable
Naming Input BNC
In Chapter 4, you connected your physical switcher inputs, including reference, primary inputs, and
alpha inputs. In this section, you will
name each physical Input BNC using the BNC Names Menu .
This allows you to use actual input names throughout the menus. Additionally, the names that you
choose will appear on the Preview Overlay output.
You can assign an Input BNC to a UMD Input address to provide the mnemonic names. If an Input
BNC is assigned to a UMD Input address, any BNC name you enter is replaced with the UMD Input
name for all the mnemonics and menus.
Use the following procedure to name your inputs:
1. Navigate to the BNC Menu 1-3 as follows:
• Press
HOME B MORE B Setup B Installation B BNC
.
2. Press
BNC Names
to display the BNC Names Menu 1-2 . This menu is specifically
designed for naming inputs.
BNC Names Menu 1-2 with Optional Mnemonic Field
• The Main Area provides an array of letters and numbers. The reverse video
highlight indicates the “selected” character — the position of which is controlled by
Note During the procedure, refer to the Input Name column on your Input
Worksheet . These names will be entered on the BNC Names Menu .
Note
The Mnemonic option is not available for the Synergy 1 .