Ross Synergy 100, Installation Manual, Page: 54 / 246

2–20 • Installation Synergy 100 Installation Guide (v16.10-S100)
Jumpers and Switches
This section provides important information about system jumpers and switches. Three sections are
included:
• Jumper Positions
• Frame Jumpers and Switches
• System Reset Notes
Jumper Positions
The following legend indicates the jumper positions used in the following section.
Jumper Positions
• Up : Jumper is away from the front of the board
• Down : Jumper is towards the front of the board
Frame Jumpers and Switches
The following figure illustrates the location of jumpers and switches on the front edge of the Frame
CPU Board :
Frame Jumpers and Switches
Caution
All product servicing should be carried out by qualified service
personnel.
The equipment still presents a safety hazard with the power switches in
the
OFF position.
Caution
Observe all static discharge precautions throughout the procedure.
1) Reset Switch
2) DIP Switch 1, Reserved 3) DIP Switch 3
4) DIP Switch 2 5) DIP Switch 4
6) Watch Dog Jumper
Front of Board
Up
Down
Rear of Frame
Front of Board
Frame CPU Board
WATCH
DOG
2 6
RESET
3
DIP SW1
DIP SW3 DIP SW2
4
DIP SW4
1 5