Ross Synergy 1, Maintenance Manual

Page: 193 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) Synergy 1 Panel Maintenance • 11–7
Replacing a Fader
This section provides instructions for replacing the fader in the Synergy 1 control panel.
Testing the Fader
As a prerequisite, use the Fader Test Menu to verify that the target fader has failed
Use the following procedure to test the target fader:
1. Navigate to the Panel Diagnostics Menu 1-2 as follows:
• Press
HOME
(to display the Main Menu 1-2 ).
•
MORE
(to display the Main Menu 2-2 ).
•
Setup
(to display the Setup Menu ).
•
Panel Diagnostics
(to display the Panel Diagnostics Menu 1-2 ).
2. Press
Fader Test
to display the Fader Test Menu .
Fader Test Menu
3. Test the fader as follows:
• Press
Normal
.
• Move the fader up and down.
• The position of the fader is shown both numerically (in hexadecimal) and
graphically. The number should range from
000 (up) to FFF (down), and the
number should be stable and jitter-free.
• If the number does not reach both limits, perform a calibration as described in the
the section “
Switcher Calibration – Synergy 1 ” on page 9-2.
This completes the procedure to to test the fader on the Synergy 1 control panel. Next you will replace
the fader on the Synergy 1 control panel.
Note Contact Technical Support for details on each display value, or if a
problem with the fader is suspected.