Ross SRG-2200, User Manual

Page: 15 / 96

SRG-2200 User Guide (v6.0) Hardware Overview • 15
Hardware Overview
This chapter outlines the front and rear panel features of the SRG-2200.
Front Panel Overview
Figure 3.1 shows the SRG-2200 Front Panel. Descriptions of the Front Panel controls and indicators appear below.
Figure 3.1 SRG-2200 — Front Panel
1. Push Button and FAULT LED Control
Press this button while the LED is cycling through status messages to move to the Fault status report list and
sequence through it.
The red LED lights to indicate a fault condition.
2. LED Display
The LED display is either Static or Animated. When Animated, it cycles through a series of Status messages
including the IP Address of the unit, Time, and others, including any reported Fault Status.
Rear Panel Overview
Figure 3.2 shows the SRG-2200 Rear Panel with description of the rear-panel connectors.
Figure 3.2 SRG-2200 — Panel
1. REF LOOP Connectors
This pair of BNCs allow the input of a remote reference signal. This signal may be NTSC or PALB/G.
With the reference signal applied to one BNC, the other BNC must be terminated (or connected to another unit
which is ultimately terminated).
1) Push Button and FAULT LED Control 2) LED Display
1) REF LOOP Connectors 5) AES AUDIO OUT Connectors 9) DIP Switches
2) Word Clock Connectors 6) COMPOSITE OUT Connector 10)ETHERNET 100-BASE T Connector
3) LTC Connector 7) TRI BLACK OUT Connectors 11) POWER Connectors
4) DARS OUT Connector 8) SDI 1 and SDI 2 Connectors 12)PSU Status LEDs
SRG-2200 SYNC GENERATOR
1 2 3 4
SPG-2200
10.xx.xx.xx
2
FAULT
1
100-BaseT
SRG-2200
+12V
PSU 1
+12V
PSU 2
DARS AES 1 WRDCLK LTC AES 2 COMPOSITE TRI/BLACK 2 TRI/BLACK 3 TRI/BLACK 4 SDI 1 SDI 2 REF LOOP
1 3 4 2
7 8 5 10 1 3 2 4 6 11
9 12