Ross SRA-8901 Series, User Manual

Page: 23 / 40

SRA-8901 Series User Manual (Iss. 02) Configuration • 3–3
Monitoring Features
The following sections describe the card-edge LEDs. Refer to Figure 3.2 for LED locations.
Figure 3.2 LED Locations
Status LEDs
Table 3.1 provides basic LED displays and descriptions.
Table 3.1 Status LEDs
LED Color Display and Description
PWR
Green
When lit green, this LED indicates that the card is functioning
normally and that no anomalies have been detected.
Flashing Green
When flashing green, this LED indicates that the Bootload button
was pressed, and the card is receiving a new software load from
the frame.
Flashing Green
and Orange When lit green with flashing orange, this LED indicates a signal
or configuration problem. Verify the signal status and settings.
Amber
When lit amber, this LED indicates the card is running internal
diagnostics while powering up.
Red
When lit red or flashing red, this LED indicates the card is not
operational. Re-seat card in frame, check the rear module type
and connections, or call Ross Video Technical Support.
Off When off, this LED indicates there is no power to the card.
IN A
Green
When lit green, this LED indicates that a valid SDI input signal is
present on the SDI IN connector.
Red
When lit red, this LED indicates that the SDI input signal is
missing or invalid on the SDI IN connector.
Daughter Card
(only available on the SRA-8901-10)
Bootload Button
PWR LED
IN A LED