Ross softGear, User Manual

Page: 22 / 70

22 • Physical Installation BAP User Guide (v1.0)
Connecting the Power Supplies
For redundancy, each power cord should be connected to a separate power source for protection
against failure of the A/C power circuit. In the event of one power supply failure, the frame load is
transferred to the other redundant power supply.
The power supply plugs into the right-hand section of the BAP rear panel. The universal power
supply supports all worldwide AC power voltages, and no power adjustments are required.
To connect the BAP to the power supplies
1. Connect the cable’s female IEC connector to the right power socket.
2. Plug the second IEC connector into left power socket.
3. Connect each supplied power cable’s three-prong male connector to an AC outlet.
4. Power on the BAP by pressing the
POWER button on the front panel. Refer to “ Front Panel
Overview ” for the location of this button.
 The fans run at full speed for a short period at the startup.
Warning
— In some countries, it may be necessary to supply the correct mains supply cord. Use only
an approved IEC 320 C-13 type A/C line cord rated for a minimum 10A at 250V and certified for the
country of use.
Warning Hazardous Voltages
— The safe operation of this product requires that a protective
earth connection be provided. This protective earth is provided by the grounding conductor in the
equipment’s supply cord. To reduce the risk of electrical shock to operator and service personnel, this
ground conductor must be connected to an earthed ground.
Gb 1 Gb 2
To Power Source 2 To Power Source 1