BAP User Guide (v1.0)
Hardware Overview • 19
Hardware Overview
This chapter presents information on the BAP hardware.
Front Panel Overview
This section provides a general overview of the features of the BAP front panel.
Figure 7 BAP — Front Panel (Door Removed)
1. POWER Button
This is the main power button for the BAP.
Rear Panel Overview
This section provides an overview of the connections and cabling designations for the BAP rear
panel.
Figure 8 BAP — Rear Panel
1. VGA Port
Use this port to connect a monitor if you do not have access to a network with DHCP for the initial
Ethernet setup, or if you have a need to reset your BAP static IP address outside of DashBoard. If
the VGA Port on the front panel is also connected to a monitor, this connection supersedes it.
2. Gb1 Ethernet Port
This standard 10/100/1000 Base-TXRJ45 connector is used to connect the BAP to your facility
network. This connector is required to bridge the external Ethernet network to the local
communication bus for monitoring and controlling the BAP using DashBoard. This port is also
used for software upgrades.
3. Gb2 Ethernet Port
This port is not implemented.
4. USB Port(s)
Use each port to connect a keyboard and mouse if you have a need to reset your BAP static IP
address outside of DashBoard.
1
Gb 1
Gb 2
8
9
5
1
2
3
4
6
7
Summary of Contents for softGear
