54 • Monitoring
GPI-8941 User Guide (v9.0)
Monitoring the GPI Output Status
The GPI-8941 card handles all GPI Output commands in the order received. The card reports status to all active
connections. A report can be generated, for each GPI output, detailing the commands sent via the GPI output
connection on the rear module.
If the
GPI All Configuration
box is selected in the
Config
tab, you can change the settings for all GPI Outputs
on the
Report
tab.
For More Information on...
• the
GPI Output Setup
tab, refer to the section “
• the messages displayed in the Report tab, refer to the section “
To set up reporting on the commands for the GPI outputs
1. From the
Tree View
, select the node for the GPI-8941 card you want to monitor.
2. Select the
GPI Output Setup
tab.
3. Select the
Report
tab located at the bottom of the
GPI Output Setup
tab.
4. Use the corresponding
RossTalk Report
menu to specify when an action is reported via the RossTalk protocol.
5. Use the corresponding
GPInet Report
menu to specify when an action is reported via the GPInet protocol.
Summary of Contents for openGear GPI-8941 Series
