Ross OpenGear DSS-8224, User Manual

Page: 38 / 47

38 • DashBoard Menus DSS-8224 User Guide (v6.0)
Dual 2x1 Mode
Table 8.7 summarizes the options and read-only information available in the Remote Control tab when the
DSS-8224 is operating in Dual 2x1 Mode.
Output 1 Source Input 1 BNC 1 is the source for Output 1
Input 2 BNC 9 is the source for Output 1
Input 3 BNC 2 is the source for Output 1
Input 4 BNC 10 is the source for Output 1
Output 2 Source Input # Displays the source for Output 2 (the same source as
assigned to Output 1)
Table 8.7 Remote Control Menu Items - Dual 2X1 Mode
Item Parameters Description
Operating Mode
(read-only) Dual 2x1, Two
independent
Outputs • Card is operating in Dual 2x1 Mode
•
JP4
is set to
2x1
•
JP9
is set to
NORMAL
Auto Change Over
Trigger
a
Loss of Signal* •
JP7
is set to
RCLK
or
EQ
• The primary input causes the output to switch to the
secondary input
Loss of Lock •
JP7
is set to
RCLK
• The primary input causes the output to switch to the
secondary input
Output 1 Auto Change
Over Mode Disabled Disables the ACO Mode. User can assign any source
for Output 1 from the
Output Source Settings area.
Enabled, Primary
Source: Input 1
b
Assigns BNC 1 as the source for Output 1
Enabled, Primary
Source: Input 2
a
Assigns BNC 9 as the source for Output 1
Enabled, Primary
Source: Input 3
c
Assigns BNC 2 as the source for Output 1
Enabled, Primary
Source: Input 4
b
Assigns BNC 10 as the source for Output 1
Output 2 Auto Change
Over Mode Disabled Disables the ACO Mode. User can assign any source
for Output 2 from the
Output Source Settings area.
Enabled, Primary
Source: Input 1
a
Assigns BNC 1 as the source for Output 2
Table 8.6 Remote Control Menu Items - 4X1 Mode
Item Parameters Description