Ross OpenGear DSS-8224, User Manual

Page: 37 / 47

DSS-8224 User Guide (v6.0) DashBoard Menus • 37
Remote Control Tab
The Remote Control tab is only available when the DSS-8224 is configured for Remote Control (
JP8
is set to
REMOTE
). The options available in the Remote Control menu depends on the mode that the DSS-8224 is
operating in.
4x2 Mode
Table 8.5 summarizes the read-only information displayed in the Remote Control tab when the DSS-8224 is
operating in 4x2 Mode.
4x1 Mode
Table 8.6 summarizes the read-only information available in the Remote Control tab when the DSS-8224 is
operating in 4x1 Mode.
Table 8.5 Remote Control Menu Items - 4X2 Mode
Item Parameters Description
Operating Mode 4x2 • Card is operating in 4x2 Mode
•
JP4
is set to
4x1
•
JP9
is set to
NORMAL
Auto Change Over
Trigger Loss of Signal On a Loss of Signal, the primary input causes the output
to switch to the secondary input.
Output 1 Auto Change
Over Mode Disabled ACO Mode is disabled
Output 2 Auto Change
Over Mode Disabled ACO Mode is disabled
Output # Source Input 1 BNC 1 is the output source
Input 2 BNC 9 is the output source
Input 3 BNC 2 is the output source
Input 4 BNC 10 is the output source
Table 8.6 Remote Control Menu Items - 4X1 Mode
Item Parameters Description
Operating Mode 4x1 • Card is operating in 4x1 Mode
•
JP4
is set to
4x1
•
JP9
is set to
FOLLOW
Auto Change Over
Trigger Loss of Signal On a Loss of Signal, the primary input causes the output
to switch to the secondary input.
Output 1 Auto Change
Over Mode Disabled ACO Mode is disabled
Output 2 Auto Change
Over Mode Disabled ACO Mode is disabled