Ross OpenGear DRA-8902 Series, User Manual

Page: 19 / 44

DRA-8902 Series User Manual (Iss. 02) Installation • 2–5
Cabling
This section provides Belden 1694A cabling details based on the card model.
DRA-8902-10 Cabling
The 8322AR-313 Full Rear Module is required for the DRA-8902-10. Each rear module occupies
two slots and accommodates one card. This rear module provides two SDI inputs, and ten SDI
outputs.(
Figure 2.4 )
Figure 2.4 Cable Connections for the DRA-8902-10
DRA-8902-16 Cabling
The 8322AR-314 Full Rear Module is required for the DRA-8902-16. Each rear module occupies
two slots, and accommodates one card. This rear module provides two SDI inputs, and sixteen
SDI outputs. (
Figure 2.5 )
Figure 2.5 Cable Connections for the DRA-8902-16
Note
— It is recommended to terminate unused outputs. You can also mute an unused output
via the Mute Outputs options available in the Setup tab of DashBoard.
OUT 1
OUT 2
OUT 3
OUT 4
INPUT A
INPUT B
OUT 5
OUT 6
OUT 7
OUT 8
OUT 9
OUT 10
BH
CHANNEL A
CHANNEL B
CHANNEL C
OUT 2
OUT 1
OUT 3
OUT 4
INPUT A
INPUT B
OUT 11
OUT 12
OUT 13
OUT 14
OUT 15
OUT 16
BI
CHANNEL C
CHANNEL D CHANNEL A
CHANNEL B
OUT 10
OUT 9
OUT 8
OUT 7
OUT 6
OUT 5