Ross NK-RP1 Series, User Manual

Page: 19 / 28

NK-RP1 Series User Guide (v2.0) Physical Installation • 19
Figure 3.7 NK-RP1 Series — Retaining Screws Locations
To remove a failed power supply from the NK-RP1 Series
1. Disconnect the failed power supply from the NK-RP1 Series chassis.
Figure 3.8 Disconnecting the Failed Power Supply
2. Remove the failed power supply by gently pulling it towards you and away from the chassis.
Figure 3.9 Removing the Failed Power Supply
To install a new power supply into the NK-RP1 Series chassis
1. Before proceeding, ensure that you have:
a. removed the front door as outlined in the section “ To remove the door from the chassis ” on page 3–18.
b. removed the power supply retaining bar as outlined in the section “ To remove the retaining bar from the
chassis ” on page 3–18.
c. if you are replacing a failed power supply, remove the failed power supply as outlined in the section “ To
remove a failed power supply from the NK-RP1 Series ” on page 3–19.
2. Insert the new power supply into the available slot inside the NK-RP1 chassis.
Retaining Screw Retaining Screw
Disconnect the failed power supply