5–2 • Operation
NK Series User Guide (1.0)
Operation Basics
Destination Keys
Selecting a destination changes the virtual destination the panel controls or switches the next time a SOURCE key
is pressed. Destinations can be selected by pressing a preset DESTINATION key
When a preset DESTINATION key is pressed, that key and its source status key (if a preset key exists) will be
illuminated. If a breakaway warning occurs, the BREAKAWAY key will flash.
The default configuration for the RCP-NK1 is shown in “
Configuration
” on page 4–1. The bottom, left hand row
of 16 keys is set to destination keys 1-16, pressing the DESTINATION SHIFT key will change the bottom row to
destination keys 17-32.
Example
Source Keys
Source switching is performed by pressing a preset SOURCE key. Selecting a source (when a TAKE function key is
not assigned) results in the controller requesting the selected source to be switched by the router to the panel’s
current destination.
If the switch request was successful the preset SOURCE key is illuminated. If the switch was not successful or
generated errors the key will flash several times quickly to indicate that an error has occurred. If a TAKE function
key is assigned, the TAKE key will be illuminated and the preset SOURCE key will flash once quickly (this
indicates that TAKE is armed). To perform the switch press the TAKE key or press any other key to cancel.
The default configuration for the RCP-NK1 is shown at the start of “
Configuration
” on page 4–1. The top, left
hand row of keys is set to source keys 1-16, pressing the SOURCE SHIFT key will change the top row to source
keys 17-32.
Example
Shift Keys
SHIFT keys allow the different pages or sets available to preset SOURCE and DESTINATION keys to be accessed.
Up to three different sets of SOURCE and/or DESTINATION keys may be accessed from the panel. The SOURCE
SHIFT keys change the current set of SOURCE keys available on the panel and the DESTINATION SHIFT keys
change the current set of DESTINATION keys available. All other keys are not affected by SHIFT keys.
When no SHIFT keys are selected, the keys are on the first or default page/set. By pressing a specific SOURCE
SHIFT or DESTINATION SHIFT key, the panel immediately changes its relevant sources or destinations to the
specified set. The SHIFT key is active when illuminated. Pressing the SHIFT key again, toggles it to the default key
set. As the sets change if a SOURCE or DESTINATION key matches the currently controlled destination or the
source status that key will be illuminated.
The default configuration for the RCP-NK1 is shown at the start of “
Configuration
” on page 4–1. The top, left
hand row of keys is set to source keys 1-16, the bottom, left hand row of keys is set to destination keys 1-16.
Selects preset destination ‘Out11’ as the panel’s controlled
destination.
Switches preset source ‘In5’ to the current destination (if TAKE is not
assigned).
Switches preset source ‘In3’ to the current destination (if TAKE is
assigned).
Out11
In5
In3
Take
USO
RESTRITO
Summary of Contents for NK-16
