Ross MUX-8552A, User Manual, Page: 18 / 32

3-2
•
User Controls MUX-8552A User Manual (Iss. 01)
MUX-8552A Jumper Locations
Use the following information to set jumpers based on your configuration requirements.
Figure 5. MUX-8552A Jumper Locations
Analog/AES Audio – JP7, JP8, JP10
Select AES on JP7 , JP8 , and JP10 if the input is to be AES digital audio. The default is AES .
Group Select – JP11
Select the incoming AES group to embed: group 1, 2, 3, or 4 via JP11 . The default is 1 .
Overwrite – JP9
Select Overwrite ON or OFF via JP9 , to allow the destructive overwrite of the selected AES group.
•
ON — Overwrites the existing audio group. The default is ON .
•
OFF — If there is pre-existing audio on the JP11 selected group, the card will allow that
audio to pass unaltered and will not insert audio. If there is no pre-existing audio on the JP11
selected group, the card will insert new audio.
EDH Insertion – JP6
Select the EDH Insertion, ON or OFF , via JP6 . The default is ON .
SMPTE Fault Reporting – JP3
Select SMPTE 269M Fault Reporting, EN ABLED or DIS ABLED, via JP3 . The default is EN .
Refer to Chapter 3, “ SMPTE 269M Fault Reporting ”, in this manual, for details on fault reporting.
SRC Select – JP1
Select SRC ON or OFF , via
JP1
, to enable the Sample Rate conversion. Select ON to enable the
MUX-8552A to automatically synchronize and convert to 48kHz any AES input from 20kHz to
103kHz. The default is
ON .