11 • Setup (Iss. 02)
Setup
Power Adapter and Supply
Connect the PS-9000 power adaptor to the power supply connector. The
PS-9000 provides up to 2A of reg5V DC (5%). The DC power cord has
a locking connector that securely fastens into the power supply DC jack on the
SEA-9003. The SEA-9003 has a standard miniature power jack (center pin
positive).
If using an adaptor other than the PS-9000, ensure that:
•
the polarity is correct
•
the voltage is +5V DC regulated to 5%
•
sufficient current for the SEA-9003 is supplied
Caution
— Use of improper adaptors may damage the SEA-9003
and will void the warranty.
Installations outside of North America using line voltages of 200-240V require a
plug, certified for the country of use, to be installed on the supplied line cord.
Refer to the section “
Important Regulatory and Safety Notices to Service
” at the front of this manual for details.
Cable Connections Overview
Connect the cables to the SEA-9003 according to the designations indicated on
the chassis label and
. The input is internally terminated at 75ohm. It is
not necessary to terminate unused outputs.
Figure 5
SEA-9003 Connections
Status LEDs
The front panel of the module has two LEDs that display the status of the input
signals and indicate whether the device is on or off.
indicates the
POWER
SUPPLY
SDI IN
SDI OUT 2
SDI OUT 4
SDI OUT 1
SDI OUT 3
