Please observe the following when using your Remote Control –
•
Change the batteries when operation becomes poor or erratic.
•
Always use two new batteries,
DO NOT
mix old and new.
•
Dispose of old batteries in an environmentally responsible way.
•
DO NOT
place spent batteries in a fire or attempt to recharge them.
•
If you are not going to use the Remote Control for an extended period then remove the
batteries to avoid the risk of leakage.
4.4 Fast Satellite Set-Up
You are now ready to switch on and adjust your dish to complete alignment (for this refer to the
seperate instructions). Turn on your TV and plug in your Satellite Receiver. Proceed as follows:-
•
Press the
“Power”
button on your Remote Control
or the
“Standby”
Button on the front panel of the
Receiver to turn the unit on.
•
Make sure your TV source is set to receive the signal
from your Recevier.
•
Press the
“Menu”
key, then using the
s
/
t
keys scroll
down to the
“Installation”
menu.
•
Press the and select
“Dish Setting”
then press
“OK”
.
•
Your Receiver has a large number of the available
Satellites already programmed in to make setting up
easier for you. You can see the Satellite names to the
left of the OSD (On-Screen Display).
•
Using the
s
/
t
keys scroll to the
“ASTRA / EURO1”
Satellite No22 from the list on the left of the screen and
press
“OK”
.
•
Now refer back to your
“Satellite Dish Installation
Guide”
to fine tune your signal reception.
•
Once you are satisfied with your signal levels as
displayed in the two bars (Strength, Quality) towards
the bottom of the Dish Setting Menu (try to obtain
better than 50% for both) you are then ready to search
for channels.
•
Now press numeric key
“3”
(Search) and from the drop
down menu on the right of the screen, as shown select:
“Scan Class”
- Auto,
“Scan Mode”
- FTA,
“Network”
- OFF, using the
t
and keys scroll
down to
“Start Search”
and the press
“OK”
button.
7
t
t
t
/
