11 • Setup (Iss. 05)
Setup
Power Adapter and Supply
Connect the PS-9000 power adaptor to the power supply connector. The
PS-9000 provides up to 2A of reg5V DC (5%). The DC power cord has
a locking connector that securely fastens into the power supply DC jack on the
ADR-9039. The ADR-9039 has a standard miniature power jack (center pin
positive).
If using an adaptor other than the PS-9000, ensure that:
•
the polarity is correct
•
the voltage is +5V DC regulated to 5%
•
sufficient current for the ADR-9039 is supplied
Caution
— Use of improper adaptors may damage the ADR-9039
and will void the warranty.
Installations outside of North America using line voltages of 200-240V require a
plug, certified for the country of use, to be installed on the supplied line cord.
Refer to the section “
Important Regulatory and Safety Notices to Service
” at the front of this manual for details.
Cable Connections Overview
Connect the analog input and SDI output cables to the ADR-9039 according to
the designations indicated on the chassis label and
. The input is
internally terminated at 75ohm. It is not necessary to terminate unused outputs.
Figure 5
ADR-9039 Connections
POWER
SUPPLY
CVBS REF IN
SDI REF
OUT 2
SDI REF
OUT 4
SDI REF
OUT 1
SDI REF
OUT 3
