Rosler EQTrace TD, Quick Manual

Page: 4 / 19

Software­Technik GmbH
EQTrace TD/TD­Key
© 2011­2019 Rösler Software­Technik Entwicklungs­ und Vertriebsgesellschaft mbH, Germany Page 4/19 13/06/2018
Wiring table:
The LED´s are at the bottom of the device. When installed they are covered
(manipulation and theft protection)
.
The allocation can be obtained from the type
plate.
LED ­ states
The installed LED's can display the following states when operating voltage is
supplied:
white
brown, green
yellow
VPP (plus, max)
GND (minus)
Input 1 (ignition)
Output (max 500 mA,
switched against minus)
Red LED
1. LED flashes every 2 seconds: The device is on.
2. LED flashes every 5 seconds: The device is in energy saving mode.
3. LED flashes two times every 5 seconds: The device is awake, i.e. sending
data, in energy saving mode.
Green LED
1. LED is off: The device is not connected to the GSM network and has no
GPS signal.
2. LED flashes shortly every second: The device is connected to the GSM
network, but has no GPS signal.
3. LED flashes long every second: The device is connected to the
internet and server, but has no GPS signal.
4. LED flashes long and two times shortly every second: The device is connected
to the internet and the server, and has GPS signal.
grey
rose
red
blue
Input 2
Input 3
Inpu 4