Roshults 200015, User Manual, Page: 8 / 12

8 / 12
EN
Module Cooker Hob 50 - NG
U S E R M A N UA L
8 / 12
C. The inlet end of the corrugated pipe is connected to the gas
valve, and the other end is connected with L type connector.
D. Gas valve.
E. The ends of the pipes connected to Valve and Burner.
Battery installation
The battery cover is located the left side of the product’s bottom
shell, as shown in the figure. Install the battery in the box according to
the positive and negative directions. Before assembling the battery
remove the drip tray. If the ignition is reduced frequently during using,
replace the battery in time. In order to guarantee ignition system is
effective for a long time, please use high-energy alkaline batteries.
1
2
Lighting the Cooker Hob
1. Press and turn the knob to “HIGH”,
at the same time. The ignition electrode
can be heard continuously and hold for
3 to 5 seconds.
2. If ignition does not occur in 5 seconds,
turn the knob to “OFF”, wait 5 minutes and
repeat lighting precedure.
3. After fire safety protection device (thermocouple induction)
starts, release the knob.
Lighting Using match light with an extension rod
If the burner will not light after several attempts then the burner can
be match lit.
1. Turn OFF all burner valves.
2. Place a lighted match on an extension rod and hold next to the
burner.
3. Turn the control knob to the “HIGH” position and press knob.
Burner should light immediately.
4. If the burner does not light in 4 seconds turn the knob off, wait 5
minutes and repeat above procedures.
Warning!
Keep your face and hands as far away from the grill as possible when
lighting it.
OFF
HIGH
Drip tray