6
User Manual
PCI 56Kbps V.92 Data/fax Voice Modem Card
RC403
the *B command. The format of the response is shown by the example below (delay times are
shown as hours:minutes:seconds). If no numbers are delayed, only the OK result code is issued.
Example:
NO. - PHONE NUMBER -DELAY
------ -------------------------------------------
; 8264734660 2:00:00
2; 753263466 2:00:00
3; 2587334662 0:02:00
4; 753265663 0:03:25
5; 745993664 0:0:45
OK
V.92 +P and –Q Commands
This section describes the +P (PCM DCE) and –Q commands and parameters used to control the
V.92 Mode operation.
+PCW - Call Waiting Enable
This command controls the operation of the modem in the presence of call waiting.
Syntax
+PCW=<value>
Defined Values
<value> Decimal number corresponding to the selected operation.
0 Request modem-on-hold if enabled by +PMH and collect caller ID information if enabled by
+VRID. Toggle V.24 circuit 25. (Default.)
Hang-up.
2 Ignore call waiting.
Result Codes
OK <value> = 0, , or 2.
ERROR Otherwise.
Reporting Selected Value(s)
Command: +PCW?
Response: +PCW: <value>
Example: +PCW: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +PCW=?
Response: +PCW: (<value> range)
Example: +PCW: (0,,2)
+PMH - Modem-on-Hold Enable
This command controls the selection of modem-on-hold in the modem. The action of the modem
in response to modem-on-hold events is determined by the state of this command as well as the
