Rosen Entertainment Systems
Copyright 2007 all rights reserved
HE0780D Installation Guide
AP1024 Rev A
Page 4
REMOTE
POWER
A/V OUTPUT
A/V OUTPUT
FMM OUTPUT
MONITOR
B
MONITOR
A
IR
B
IR
A
AUX 2
Wiring diagram
6 Removing the factory headrests
IMPORTANT!
Do NOT start this step until you have inspected the seats and factory headrests for any
obstructions.
You will need to remove the existing factory headrests. The following steps will guide you through this
process.
Step 1:
Determine if a locking device is present on the factory headrest. Locking devices are
usually
a button or small push pin located at the base of the headrest post(s).
Step 2:
If a locking device is present, press and hold the lock release, and pull firmly upward on the
headrest. If no locking device is visibly present refer to the vehicle’s owners manual or the vehicle’s
manufacturer for further instructions.
Red – 12V ACC (switched)
Black – Ground
Gray – 12V Switch-FMM
Black – Ground-FMM
Blue – 12V (Aux source)
Black – Ground (Aux source)
Purple – (2.5m)Antenna
Interface Harness
Black
Black
Gray
Gray
