Installation Guide Toyota Camry
Rosen Entertainment Systems
Copyright 2011 All Rights Reserved
Installation Guide
DP-TY0714 Rev F
Page 4
Unplug Electrical Connections
Carefully remove all harnesses from rear of OEM radio
*JBL Audio equipped vehicles will require additional part #
DP-TYJBL1 audio interface
Remove Factory Brackets/Clips
Remove factory brackets and clips from OEM radio
(8 x 10mm bolts 4 Left/4 Right)
Re-Install Factory Brackets/Clips on Rosen
Unit
Re-install factory brackets/clips on Rosen unit
(8 x 10mm bolts 4 Left/4 Right)
LOCATING REMOTE COMPONENTS
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the vehicle.
And mount the iPod Interface Connector in the vehicle. The following steps will help guide you
through this process.
STEP
3
Use Caution around SRS Components
I
t is the
installer’s responsibility
to ensure that the safety
equipment in the vehicle is
NOT
adversely affected by installation
of this system. Ensure that the routing of the harnesses do NOT
obstruct airbags, SRS or other safety devices.
Mount the GPS and Sat Radio antenna in a
location on the exterior of the Vehicle
Route the GPS harness away from other power harnesses in the
vehicle.
This will help to ensure optimum performance of the GPS
system.
CAUTION
