Rosen Aviation
Remote Display System
Document Number: 105478
Revision: F
Date: 06/23/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 24 of 38
10.1.3. Comp/RGB 1
Use Comp/RGB 1 to specify which input source the Component/RGB channel 1 will use.
The options for channel 1 to display are either Component or RGB.
Highlight
Advanced
Comp/RGB 1
and press
ENTER
.
Use the ▲▼ buttons to set the option
and then press
ENTER
.
Select
Back
and press
ENTER
to return to the Technician Menu.
Press
EXIT
when you are ready to exit the OSD.
10.1.4. Comp/RGB 2
Use Comp/RGB 2 to specify which input source the Component/RGB channel 2 will use.
The options for channel 2 to display are either Component or RGB.
Highlight
Advanced
Comp/RGB 2
and press
ENTER
.
Use the ▲▼ buttons to set the option
and then press
ENTER
.
Select
Back
and press
ENTER
to return to the Technician Menu.
Press
EXIT
to exit the OSD.
10.1.5. 3D Comb Filter
(Composite only)
When set to Enabled, the display will eliminate dot crawl and some
noise on stationary portions of the picture.
Highlight
Advanced
3D Comb Filter
and press
ENTER
.
Use the ▲▼ buttons to set the option
and then press
ENTER
.
Select
Back
and press
ENTER
to return to the Technician Menu.
Press
EXIT
to exit the OSD.
10.1.6. Composite Sig (Signal)
(Composite only)
This is a read-only screen that shows the signal strength of the
currently viewed Composite source. Composite Signal strength ranges from
0 to 1.25 Vpp in 0.25V increments. It will read NA (not available) if a Composite
source is not active or the
10.1.7. AGC (Automatic Gain Control)
(Composite only)
This option is a signal compensation tool that will accommodate for
strong and weak Composite signals.
Highlight
Advanced
AGC
and press
ENTER
.
Use the ▲▼ buttons to set the option
and then press
ENTER
.
Select
Back
and press
ENTER
to return to the Technician Menu.
Press
EXIT
to exit the OSD.
