Rosemount Oxymitter 4000, Instruction Bulletin

Page: 58 / 127

IB-106-340
3-1
SECTION III. STARTUP
Install all protective equipment covers
and safety ground leads before equip-
ment startup. Failure to install covers
and ground leads could result in serious
injury or death.
3-1. GENERAL.
a. Verify Mechanical Installation. Ensure the
Oxymitter 4000 is installed correctly (Section II,
INSTALLATION).
b. Verify Terminal Block Wiring.
1. Remove screw (32, Figure 6-1), gasket (33),
and cover lock (34) that secure the terminal
block cover. Remove the cover to expose
the terminal block (Figure 3-1).
2. Check the terminal block wiring. Be sure the
power, 4-20 mA signal, and logic outputs
are properly connected and secure.
3. Install the housing cover on the terminal
block and secure with cover lock (34, Figure
6-1), gasket (33), and screw (32).
4. For an Oxymitter 4000 with an integrally
mounted SPS 4000, remove screws (26,
Figure 6-11) and terminal cover (27). Check
that the power and signal terminations are
properly connected to terminal strip (25)
and secure according to instructions in Sec-
tion II, INSTALLATION.
5. Install terminal cover (27) and secure with
screws (26).
A
C
L1
A
C
N
+ + - -
4-20
500 VA
SERIAL NO.
TAG NO.
OXYMITTER 4000
WATTS: VOLTS:
FUSE: LINE OUTPUT:
Rosemount Analytical Inc.
Orrville, OH 44667-0901
85-264 VAC 48-62 Hz
TM
800-433-6076
4-20 mA
R
5 Amps
TM HART
SMART FAMILY
DIAGNOSTIC
ALARMS
TEST
POINTS
HEATER T/C
HEATER
02 CELL
CALIBRATION
CALIBRATION RECOMMENDED
02 CELL mV +
02 CELL mv -
HEATER T/C +
HEATER T/C -
INC INC
DEC DEC
HIGH
GAS
LOW
GAS
CAL
TEST GAS +
PROCESS -
% 02
SW2
TP1
J1
TP2
TP3
RED YEL
GRN ORG
TP4
TP5
TP6
ON
4-20 mA
SIGNAL
LOGIC I/O
GROUND LUGS
TERMINAL
BLOCK
OXYMITTER 4000
ELECTRONICS
HOUSING
26170036
Figure 3-1. Integral Electronics