Rosemount 752, Reference Manual

Page: 53 / 60

Reference Manual
00809-0100-4377, Rev BA
September 2010
C-5
Rosemount 752
SECURITY_IO 65 0:
Uninitialized
1: Off
2: On 0 E Read
Only Status of Security jumper/switch
SIMULATE_
STATE 66 0 - 3 1 E Read
Only The state of the simulate jumper
0 = Uninitialized
1 = Jumper/switch off, simulation not allowed
2 = Jumper/switch on, simulation not allowed (need to cycle
jumper/switch)
3 = Jumper/switch on, simulation allowed
DOWNLOAD_
MODE 67 0 - 2 1 E Gives access to the boot block code for over the wire
downloads
0 = Uninitialized
1 = Run Mode
2 = Download Mode
RECOMMENDED
_ACTION 68 0 E Read
Only Enumerated list of recommended actions displayed with a
device alert.
FAILED_PRI 69 0 - 15 0 N/A Designates the alarming priority of the FAILED_ALM.
FAILED_ENABLE 70 0 E Read
Only Enabled FAILED_ALM alarm conditions. Corresponds bit for
bit to the FAILED_ACTIVE. A bit on means that the
corresponding alarm condition is enabled and will be
detected. A bit off means the corresponding alarm condition is
disabled and will not be detected.
FAILED_MASK 71 See Table 25 0 E Mask of FAILED_ALM. Corresponds bit of bit to
FAILED_ACTIVE. A bit on means that the condition is
masked out from alarming.
FAILED_ACTIVE 72 0 E Read
Only Enumerated list of failure conditions within a device.
FAILED_ALM
. Unacknowledged
. Alarm State
. Time Stamp
. Subcode
. Value 73 N/A
R/W
RO
RO
RO
RO
Alarm indicating a failure within a device which makes the
device non-operational.
Only “Unacknowledged” subindex is writeable (R/W). The rest
are Read Only (RO)
MAINT_PRI 74 0 - 15 0 N/A Designates the alarming priority of the MAINT_ALM
MAINT_ENABLE 75 0 E Read
Only Enabled MAINT_ALM alarm conditions. Corresponds bit for
bit to the MAINT_ACTIVE. A bit on means that the
corresponding alarm condition is enabled and will be
detected. A bit off means the corresponding alarm condition is
disabled and will not be detected.
MAINT_MASK 76 See Table 26 0 E Mask of MAINT_ALM. Corresponds bit of bit to
MAINT_ACTIVE. A bit on means that the condition is masked
out from alarming.
MAINT_ACTIVE 77 0 E Read
Only Enumerated list of maintenance conditions within a device.
MAINT_ALM
. Unacknowledged
. Alarm State
. Time Stamp
. Subcode
. Value 78 N/A
R/W
RO
RO
RO
RO
Alarm indicating the device needs maintenance soon. If the
condition is ignored, the device will eventually fail.
ADVISE_PRI 79 0 - 15 0 N/A Designates the alarming priority of the ADVISE_ALM
ADVISE_
ENABLE 80 0 Read
Only Enabled ADVISE_ALM alarm conditions. Corresponds bit for
bit to the ADVISE_ACTIVE. A bit on means that the
corresponding alarm condition is enabled and will be
detected. A bit off means the corresponding alarm condition is
disabled and will not be detected.
Parameter Index Valid Range Initial Value Units Other Description