The AnoSkybox™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #03INAnoSkyboxTopLoad4Way
Incept-2.07.03
Instructions for Assembly continued
7
Step 4
Assemble the vertical rail assemblies
onto the upward facing corner brackets
already inserted into the bottom rails.
All four brackets should go into the
vertical rails at one time.
Note: The last vertical rail will be
tensioned. This is normal.
Note: Insert end of spine without the
predrilled holes. Holes should
remain at the top of the AnoSkybox
for hanging.
Step 5
Insert corner brackets into ends
of split rails, 1 per end. Use thumb
as shown in illustration.
Step 6
Assemble split rails onto top ends
of vertical rails, one inside and one
outside of each side of the AnoSkybox.
Step 7
Insert and change signs through top
of each side.
Step 8
Assemble hanging hardware by
inserting hooks through holes on the
spines.
Step 9
Hang the completed assembly.
Note: Steps 7-9 illustrate a 3-Way
AnoSkybox. Assembly is the same for
a 4-Way
AnoSkybox™
4
5
6
8
9
Top Load 3-Way Instruction Sheet
Page 2 of 2
