ROSE BRAND KABUKI SYSTEM, Installation Instructions Manual, Page: 3 / 8

ROSE BRAND
NJ 800.223.1624 CA 800.360.5056
Step 1 : Layout all Kabuki units on the floor below batten pipe or truss. Units with trip mechanisms indicated by
a plastic cover go on the ends with the plastic cover facing off-stage (If trip mechanisms are not installed, see
Trip Mechanism instructions). Loosen thumb screws on all pipe clamps completely. You may also need to
loosen the pipe clamp bracket nuts slightly (just enough so they slide) using a 7/16” wrench.
Figure 2
Step 2 : Starting from the center of the batten pipe or truss, hang one Kabuki unit (aligned with center) and
tighten the pipe clamp thumb screws and bracket bolts .
Step 3 : Hang another Kabuki unit adjacent to the first and tighten the pipe clamp thumb screws only.
Pipe Clamp Thumb Screw
Pipe Clamp Bracket Nuts