Rosco Vision SAFE-T-SCOPE 360, Installation Manual And User'S Manual

Page: 6 / 29

6
Installation
General Guidelines
•
Please read the entirety of this manual before beginning installation.
•
Double-check all measurements before drilling any holes or making any other vehicle modifications.
•
Each vehicle has its own system and features. Please refer to your vehicle’s manual for details.
•
Turn the ignition key off while installing the cables and device.
•
Make sure to connect Ground wire first!
•
Select a secure, protected location for the ECU module.
•
Remove fuse from fuse holder during installation. Replacing fuse should be the last step.
•
Keep protective films in place during installation to prevent scratches, especially on monitor.
•
Use caution when removing and replacing vehicle interior panels.
•
Read wiring diagrams carefully before connecting wires.
•
Gather and prepare all tools prior to installation.
•
Minimum cable bend radius is two inches (2”).
•
For ease of installation and repair, it is recommended to use a fused power terminal block.
•
DO NOT attempt to clean ECU with any liquids
•
DO NOT attempt to disassemble, repair, or modify the products.
•
DO NOT adjust DIP switches on ECU labeled “SW.”
•
Mount ECU in a location that is not exposed under normal use conditions. I nside the driver’s switch panel is
an acceptable location.
•
DO NOT attempt to remove or modify ECU housing. ECU housing is coated to block EMF, any tampering
could compromise performance.
•
Make sure to mount ECU in such a way that calibration port is accessible.
•
Make sure ECU has ample clearance on all sides (except bottom) to allow proper airflow for cooling. Bottom
of ECU can be mounted flush to a surface.
MONITOR NOT INCLUDED