Rosco Vision SAFE-T-SCOPE 360, Installation Manual And User'S Manual

Page: 20 / 29

20
•
When prompted, insert SD card into the Calibration Module.
•
A series of progress bars will appear indicating the status of the calibration upload.
•
When calibration upload is complete, monitor will display the following:
•
Notice that “CALIB. INFO.” AND “CAR” are marked “OK.”
•
Remove SD card.
•
Turn vehicle ignition off. Calibration is now complete.
Calibration Reuse
•
For vehicles with the same body dimensions, it is possible to re-use the same calibration, HOWEVER, it is
essential that great care be taken to duplicate camera placement on all vehicles. Cameras can be offset by
up to
0.5” without affecting calibration. Additionally, camera mounting angle must not deviate more than 4 ⁰
from original camera placement. When possible, use mounting jigs or templates to ensure repeatable
camera placement