STSK4532, STSK4533 Installation/Users Manual
10
TESTING
How to Test:
1. Apply the parking brakes.
2. Turn Ignition on.
3. Shift into reverse gear.
4. Image should appear on the monitor.
Trouble Shooting
Problem
Solution
No video signal appears while
reversing the vehicle.
Check all camera connections (ex.
Power, Ground, AV1, AV2)
Press AV1/AV2 button to change video
inputs
Check the rearview camera wiring and
connection.
Video image is not sharp.
Clean the lens of the camera
Maintenance:
Always keep camera clear from dirt, snow, and mud. Clean camera with a soft
towel and low pressure water.
11
CAMERA INSTALLATION STSC106
1.
Locate rear license plate and
remove screws.
(See Figure 7)
2.
Find suitable location to drill
connector hole above/behind license plate.
3.
Once the location is chosen, drill pilot hole to
the inside of the vehicle using a 5/16 drill bit. Be sure to
clear any obstacles before drilling hole.
(See Figure 8)
Push connector through hole.
5
. Mount camera on license plate and use provided screws to mount
license plate back into position.
(See Figure 9)
6.
Use supplied grommet to plug up drilled hole or use sealant to
close and secure hole.
7.
Connect camera to extension harness previously wired.
8.
You have the option to change the camera angle. Two set screws
located in the front of the camera may be loosened to adjust the
camera angle. After the camera angle is adjusted just re-tighten
the screws.
CAMERA INSTALLATION STSC112
1.
Find a flat centered location on
your bumper.
(Figures 3)
2
. Make sure clearance behind
camera location is unobstructed.
3.
Using a 1.25” (31mm) hole saw (not included),
carefully drill a hole in the surface. (See Figure 4)
4.
Remove retaining rings from camera.
5.
Place harness through hole until camera is flush. Do not run the
cable over sharp edges or corners. Do not kink the cable. Keep the
cable away from hot and rotating parts.
(See Figure 5)
6.
Replace retaining rings onto body of camera.
DO NOT TIGHTEN.
7.
Connect camera to extension harness.
(See Figure 6)
8.
Verify Camera Orientation by viewing image on monitor.
9.
Tighten rings behind camera until completely snug.
10.
Fasten all cable runs, and secure all excess cable.
Figure 3
Figure 4
Figure 5
Figure 8
Figure 9
Figure 7
Figure 6