USER MANUAL - SL1 SWITCH
3
USER MANUAL -
UBB
1.
Connect the UBB to a power source (DMG EPS, DMG Battery mount or any
12 to 30VDC power supply)
2.
Connect the Mini SWITCH or SL1 SWITCH to the UBB
3.
Turn on the UBB by selecting which light you are powering (SL1 or Mini)
Four modes are available :
•
LOCAL MODE
•
DMX MODE
•
Wireless DMX MODE
•
CUSTOM MODE
LOCAL MODE:
WIRELESS DMX MODE:
DMX MODE:
Control the UBB remotely with the Wireless DMX
protocol.
•
Make sure the Wireless DMX antenna should be intalled
•
Press the dimmer button to enter the DMX start number of
the UBB
•
Validate by pressing go
In Wireless DMX mode,when in receiver mode, the green
dot indicates your device is connected to a receiver, the red dot indicates you are not
connected to a receiver. To unlink a receiver, press the «SWITCH» button for 5 seconds
until the dot blinks in red.
Control the UBB locally with the dimmer button.
•
Press the SWITCH button to change between CCT and
intensity control
•
Press CCT button for a quick change between 3200°K and
5600°K
•
Press the dimmer button to select coarse or fine intensity
tuning
Control the UBB remotely by cable with the DMX
protocol.
•
Press the dimmer button to enter the DMX start number of
the UBB
CUSTOM MODE:
In custom mode the UBB acts as a translator between
different protocols. It still controls the SL1 SWITCH or
Mini SWITCH connected to it.
•
Make sure the Wireless DMX antenna should be installed if
sing Wireless DMX.
•
Make sure the Wi-Fi antenna should be installed if using Wi-Fi.
•
Press the dimmer button to select data input, data output
and DMX address.
•
Validate by selecting «Go».
If Wi-Fi input is selected, the UBB creates a Wi-Fi networks with the following
specifications:
SSID: UBB serial number
Password: dmglumiere
These informations can be find in the “info” section of the UBB menu.
Wireless DMX dot is red when no signal is received, green when the UBB is connected
to a Wireless DMX emitter.
•
To unlink all receivers, press the «SWITCH» button for 5 seconds until the dot blinks in red.
To link all receivers, do a short press on the «SWITCH» button.
