13
DMX oPeRaTIon
A single channel is required for output intensity control via DMX. In order to set the DMX address, an optional
DMX Programming Cable (sold separately) is needed, as well as the free Image Spot Addressing Software that
can be downloaded at www.rosco.com/ImageSpot.
To set the DMX address on the Image Spot IP40 unit, you will need the USB to RJ45 Cable accessory, sold
separately. Plug the USB connector into the computer running the Image Spot Addressing Software, and the
RJ45 connector into the receiver on the rear panel of the fixture. Follow the prompts from the software to set
address (set value). The output of the unit can also be tested by entering a value between 255 (100%) and 1 (0%).
Summary of Contents for 296000040401
Page 2: ...2...
