i910GML-DCQIC6/ i915GM-DCQI
40
1.8.10
Primary IDE Connector (IDE1)
This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA 100/66 signal cable
has three connectors: a blue connector for the primary IDE connector on the motherboard,
a black connector for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),
and a gray connector for an Ultra DMA 100/66 IDE master device (hard disk drive). If you
install two hard disk drives, you must configure the second drive as a slave device by
setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings.
z
Pin 20 on the IDE connector is removed to match the covered
hole on the Ultra DMA cable connector. This prevents incorrect
insertion when you connect the IDE cable.
z
Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE
devices.
z
Orient the red markings (usually zigzag) on the IDE ribbon cable
to Pin 1.
